How to Install a 66-Inch Plywood Ceiling Fan with Light

Quick answer

Installing a 66-inch plywood ceiling fan with light requires a reinforced ceiling box, two-person lifting assistance, and careful wiring of the DC motor. Follow the steps below to mount, wire, and balance your fan safely.

Step-by-step installation guide

1. 1. Prepare the ceiling mount: Turn off power at the breaker. Remove the existing fixture and inspect the ceiling box. If it is not fan-rated, install a metal brace box rated for at least 70 pounds. Secure the mounting bracket provided with your fan to the box using the included hardware. Common mistake: using a standard light fixture box. Always use a fan-rated box to prevent the fan from pulling loose.
2. 2. Assemble the fan motor and blades: On a clean, padded surface, attach the 8 plywood blades to the motor using the screws provided. Tighten each screw evenly but do not overtighten. If your fan has a light kit, install the light fixture now according to the manual. Checkpoint: ensure all blade screws are snug but not stripped. Uneven tightness can cause wobble later.
3. 3. Lift and hang the fan: With a helper, lift the assembled fan and hook the motor housing onto the mounting bracket. Secure the fan using the locking pin or screws as directed. For a 66-inch fan, two people are essential to avoid dropping the unit or damaging the blades. Common mistake: attempting to lift alone. The weight and size make it unsafe and likely to damage the blades.
4. 4. Wire the fan and light: Connect the fan wires to the house wiring: white to white (neutral), black to black (live), and green or bare copper to ground. If your fan has a DC motor, follow the color codes in the manual exactly. Secure each connection with wire nuts and wrap with electrical tape. Checkpoint: double-check that the ground wire is connected. A missing ground can cause electrical shock or fan malfunction.
5. 5. Attach the canopy and blades: Slide the canopy up to cover the mounting bracket and tighten the screws. Then install the blade holders (if separate) and attach each blade. Ensure all blades are oriented the same way and spin freely. Common mistake: blades installed upside down or mismatched orientation. Check the blade pitch direction before tightening.
6. 6. Balance the fan: Turn power back on and run the fan at low speed. If you notice wobble, use a balancing kit (often included) by attaching clips to the blade edge until the wobble stops, then stick the weight on that spot. Repeat for medium and high speeds. Checkpoint: a slight wobble at high speed is normal for large fans, but persistent wobble at low speed indicates a blade or mount issue.
7. 7. Test the light and remote: Turn on the light and verify it works. If your fan includes a remote or wall control, pair it according to the manual. Test all speeds and the reverse function (if available) to ensure proper operation. Common mistake: forgetting to install batteries in the remote or failing to sync it. Check the manual for pairing steps.

Products mentioned in this guide

• 66″ Plywood Ceiling Fan With Light: This 66-inch ceiling fan with light features 8 two-tone plywood blades and a modern rustic design. The larger blade span and heavier plywood construction mean you need a reinforced ceiling box and two people to lift it during installation.